H
Herb
Anybody have any tricks to putting tension on belts in a 98 Civic? The
components (alternator) seems to "float" on a relatively 3 inch straight
track, with a bolt to fasten the component in place, thus placing tension
on the belt.
Seems like their is about a 2 inch gap between the component and the engine
block. Not sure if using a wrecking bar as a lever would work, as this gap
seems too large for it.
All advice cheerfully appreciated!
components (alternator) seems to "float" on a relatively 3 inch straight
track, with a bolt to fasten the component in place, thus placing tension
on the belt.
Seems like their is about a 2 inch gap between the component and the engine
block. Not sure if using a wrecking bar as a lever would work, as this gap
seems too large for it.
All advice cheerfully appreciated!
