Prelude intake manifold question ....

Discussion in 'Prelude' started by Tim Klechak, Mar 28, 2005.

  1. Tim Klechak

    Tim Klechak Guest

    O.K., seems like I only pop in here when I have a problem and need advice,
    but ........
    O.k., I did a valve job on a 1987 Prelude 1.8 carbureted engine, and am just
    about done, except I need to tighten up the intake manifold. My question is
    this ..... how the heck do you get access to the lower middle stud/nut???
    Can it be accessed by going between the carbs around any vacuum/fuel lines
    etc.??? I have the air cleaner assembly off already, including the backing
    plate. Please respond to this group AND by email if you've done one of these
    intakes before. The Haynes manual I have simply says "remove nuts & bolts"
    ...... DUUUHHH
    Any tips would be appreciated. TIA .... Timm .........
    12.az.us
     
    Tim Klechak, Mar 28, 2005
    #1
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Civic Air intake question

  2. FS HOnda prelude AEM Cold air intake plus

  3. 88 Accord DX, Blocked EGR passageway in intake manifold

  4. Exhaust Manifold / Header question (1996 Accord EX)

  5. Do I need to replace my intake manifold?

  6. 03' CRV: P0661....Intake Manifold Tuning Valve Control Circuit Low(Bank 1)

Loading...