CRX timing belt qeustions

[svtbass]

CRX timing belt qeustions


I am replacing my timing belt on my 91 CRX dx
the main crank pulley has a few notches... one that has a red line between
two other lines... and a separate single line on the pulley part that is
closest to the engine.. there is an outer ring that hold the belt for the
AC.. which marking do I line up to... the Cam is already in the correct
position
thank you in advance

 

[Eric]

CRX timing belt qeustions

I am replacing my timing belt on my 91 CRX dx
the main crank pulley has a few notches... one that has a red line between
two other lines... and a separate single line on the pulley part that is
closest to the engine.. there is an outer ring that hold the belt for the
AC.. which marking do I line up to... the Cam is already in the correct
position thank you in advance

Use the single white line which indicates top dead center. This should line
up with a pointer on the lower timing belt cover.

The red line surrounded by the two other lines likely indicates 18° +/- 2°
before top dead center and is used when setting the ignition timing with a
timing light.

I would also suggest a factory service manual as an excellent source of
information. They can be obtained from http://www.helminc.com.

Lastly, double check your timing marks after turning the engine over by hand
before attempting to start the car.

Eric