2005 pilot torque setting

Discussion in 'Pilot' started by Seamus J. Wilson, Jan 4, 2010.

  1. Replacing brake pads. What is the torque setting for the banjo bolts?
    Thank you,
    Seamus J. Wilson
     
    Seamus J. Wilson, Jan 4, 2010
    #1
  2. Seamus J. Wilson

    jim beam Guest

    if it's the same size as other honda banjos, it'll be 35N.m. assuming
    new seal washers.

    but, if you're just doing pads, why would you be removing them? you
    only need to remove the caliper pin to access the pads.
     
    jim beam, Jan 4, 2010
    #2
  3. Seamus J. Wilson

    Tegger Guest


    Are you opening the hydraulics just to replace the brake pads? I hope not.

    If you mean the two bolts that hold the caliper to the mount bracket, 25
    ft/lbs will do. I just make them "good 'n' tight".
     
    Tegger, Jan 4, 2010
    #3
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.