2003 Civic EX - brake fluid leak

Discussion in 'Civic' started by gorf, Oct 27, 2005.

  1. gorf

    gorf Guest

    Just verified that I have a fluid leak in my 2003 Civic EX. My wife and
    I had a concern about two weeks back but couldn't tell if there was a
    leak. Pretty obvious now. although it still only comes out in drops,
    probably 5-6 overnight.

    Leak is in the front behind the condenser fan towards the passenger
    side. I see two hoses running from the engine towards the front, they
    split right/left although the one on the passenger side appears to go
    down a little sooner than the one on the driver side. Both have a small
    hose coming from the engine which connects to a larger hose, a metal
    clip holds them in place (the kind that wraps around and is tightened
    with a screw).

    The driver side hose appears to be leaking fluid at the connection
    between the large hose and the small one. Fluid is following the hose
    down, dripping on a piece of the bumper and then on the concrete. Fluid
    is light brown (color of peanut butter) and is very slippery.

    Is this brake fluid? Do I need to replace the hose that is partially
    covered with brake fluid?

    I'm not going to drive the Civic until I take it in, but is it dangerous
    to drive the Civic even to a repair shop? I estimate that it's 20 miles
    to a Honda dealer, 5 miles to a general service shop. The general
    service shop may repair it under warranty since they just replaced the
    brake pads back in April (could they have caused this? would they have
    messed with the hose at this connection?).

    Thanks for any tips, I'm really looking to see if it is brake fluid and
    what safety risks there are in driving it. Other comments are welcome.
     
    gorf, Oct 27, 2005
    #1
  2. gorf

    jim beam Guest

    if it's water soluble, it's brake fluid. yes, you need the hose
    replaced. if the leak rate is not too fast, it's probably ok to drive
    to the 20 miles - you have a split circuit braking system so you'll
    still be able to stop - but take it EASY.
     
    jim beam, Oct 27, 2005
    #2
  3. gorf

    TeGGeR® Guest



    Your description is more that of power steering fluid than brake fluid.

    The brake lines within the engine bay are all very thin, and steel. The
    only rubber ones are at the wheels, and you have NO screw-type clamps on
    your brake hoses.

    Check the power steering fluid reservoir. Is the fluid low?

    Has the car been in a collision?

    What sorts of devices do you find at the ends of the hoses?




    Depends on if it's actually brake fluid or not. I don't think it is.
     
    TeGGeR®, Oct 27, 2005
    #3
  4. gorf

    gorf Guest

    Thanks for the replies, I can't trace the lines back to any particular
    source/destination from any vantage points that I have. Car was in a
    collision in July 04 and a service tech in April "fixed a hose on the
    drivetrain" that he said was bent back in the wrong position (likely
    from a bad repair after the collison). The hose has a screw clamp but
    the neighboring hose has a spring clamp. Could be power steering fluid
    though. I'll check the level tonight. Would type more but now my
    monitor's wigging out (the aperture grille bars are clicking/flashing...
    lovely).
     
    gorf, Oct 27, 2005
    #4
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.