2001 CRV Rear Window latch

Discussion in 'CR-V' started by LUKE J, Oct 25, 2007.

  1. LUKE J

    LUKE J Guest

    Hello

    I have a 2001 CRV and lately I have had problems latching the rear window to
    the
    tail gate door when closing all.

    Is there an easy fix for this? Oil something? Align something?

    I go to pull down (close the window) and is seems to want to softly bounce
    back up and not
    latch.

    Your help is appreciated.

    Thanks all
     
    LUKE J, Oct 25, 2007
    #1
  2. LUKE J

    motsco_ Guest

    --------------------------------

    Start by spraying the latch with some silicone lube which will help
    clean out any crud that may have accumulated, then 'exercise' it several
    times to work the lube in / crud out. Spray it again and if it works
    better pick up some white lithium grease. It is the recommended lube.
    Don't use anything dino-based or you will accumulate crud.

    You could also use Lock-Ease as you final lube, since it's so good for
    the door and ignition locks. I do all five locks on each of our Hondas
    yearly. It's messy so you have to wipe the key the first few times you
    use each lock. The skinny tube that comes with the can needs to be stuck
    about 1" into the tumblers. I use a small screwdriver to hold the dust
    door open.

    Here ya go:
    http://www.hondasuv.com/members/showthread.php?t=19980&highlight=lockease

    It's even CR-V specific. 'Curly'
     
    motsco_, Oct 25, 2007
    #2
  3. LUKE J

    motsco_ Guest

    --------------------------------

    Start by spraying the latch with some silicone lube which will help
    clean out any crud that may have accumulated, then 'exercise' it several
    times to work the lube in / crud out. Spray it again and if it works
    better pick up some white lithium grease. It is the recommended lube.
    Don't use anything dino-based or you will accumulate crud.

    You could also use Lock-Ease as you final lube, since it's so good for
    the door and ignition locks. I do all five locks on each of our Hondas
    yearly. It's messy so you have to wipe the key the first few times you
    use each lock. The skinny tube that comes with the can needs to be stuck
    about 1" into the tumblers. I use a small screwdriver to hold the dust
    door open.

    Here ya go:
    http://www.hondasuv.com/members/showthread.php?t=19980&highlight=lockease

    It's even CR-V specific. 'Curly'
     
    motsco_, Oct 25, 2007
    #3
  4. LUKE J

    LUKE J Guest

    Thanks!!
     
    LUKE J, Oct 26, 2007
    #4
  5. LUKE J

    LUKE J Guest

    Thanks!!
     
    LUKE J, Oct 26, 2007
    #5
  6. LUKE J

    LUKE J Guest

    Thank you
     
    LUKE J, Oct 26, 2007
    #6
  7. LUKE J

    LUKE J Guest

    Thank you
     
    LUKE J, Oct 26, 2007
    #7
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.