2000 CRV Rotors - Curly, Follow up Question

Discussion in 'CR-V' started by Face, Aug 19, 2004.

  1. Face

    Face Guest

    Hey Curly,

    Do I need to worry about any of the anti lock brake mechanisms? Are
    there even any sensors etc. around the calipers or the rotors?



    They're fairly straightforward, except you'll need an impact driver to
    crack the two Phillips head screws out that hold the rotors on. If the
    rotors don't come off easily once the screws are out, you can put a
    coulple of 8 x 1.25 mm bolts into the threaded holes to pry the rotors
    off. Wire brush the area where the rotor surrounds the hub to make it
    come off smoother.

    Face, Aug 19, 2004
  2. Face

    motsco_ _ Guest


    The sensors are up against the tone rings, which are part of the drive
    shafts, on the inside of the wheel bearing, out of your reach. You'll do OK.

    motsco_ _, Aug 20, 2004
  3. Face

    Face Guest


    You're the man!
    Face, Aug 20, 2004
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.