1998 Integra -- New Rear Caliper won't engage with parking brake

Discussion in 'General Motoring' started by gwhitney, Nov 22, 2005.

  1. gwhitney

    gwhitney Guest

    The other day I replace one of my rear brake calipers on my 1998 Acura
    Integra do to the piston being stuck. Once I put the new on one, bled
    it, and reattaching the parking brake cable, the parking brake will not
    engage on that side. The hydrolic portion of the caliper engages fine
    when applying pressure to the brake pedal. I have also tightened up
    the parking brake cable at the adjustment point under the center
    console, and that didn't help either. Does any one have any ideas on
    what else it could be? Is it a faulty new caliper? Any suggestions
    would be extremely helpful, since I am out of ideas.
     
    gwhitney, Nov 22, 2005
    #1
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. 88' Accord a/c clutch won't engage

  2. engage parking brake before shifting to park?

  3. Where does one get a brake caliper slide pin boot for a 95 Integra/Civic?

  4. Help Rear Caliper Rebuild Boot won't fit

  5. 88' Accord a/c compresser clutch won't engage

  6. Starter won't engage on 86 Accord

  7. replacing single rear brake caliper?

  8. Parking brake won't grab on one side.

Loading...