1995 Accord LX - Changing spark plugs - question

  • Thread starter Thread starter djs239
  • Start date Start date
D

djs239

Hi,

I want to change the 4 spark plugs in my 1995 Accord LX.

I noticed how deep the plugs are recessed, and am not sure about how to do
it.

A special spark plug tool is what I need, of course...

My question is this a complicated task if I get the right spark plug tool ?

And, are there any special considerations I need to be aware of when
changing the plugs ?

Is it necessary to vacuum or blowout the plug holes before removing them to
prevent debris from falling into the holes ?

I've never replaced the plugs myself and don't want to screw it up...

Thanks for any info
 
Mom's car is a "95 LX. I use a 5/8'' plug socket on a 6'' extension.
Sometimes the plug will slip out of the socket when it's ready to lift
out of the hole. I have a foot long piece of gas line hose that slips
over the end of the plug to reach it out. If there is evidence of motor
oil on the threads of the old plugs, the valve cover gaskets need to be replaced.
Use N.G.K. or Nipon-Denso plugs, and they will be set to the correct
gap. (1.1 mm ) There is a metal "crush" washer on the new plugs. Tighten
them by hand until you feel the washer contacts the head, and then
tighten another half to three quarter turn with the wrench.
Do them one at a time, so the wires don't end up on the wrong plug.
Good Luck! bob
 
Definitely a good idea to blowout the recesses before removing the plugs.
Most "spark plug" sockets have a rubber insert to grab the plug.
When you put the new plug in, use the plug socket and extension without the
handle to get the plug started. Then attach the handle and tighten as N.E
Ohio Bob says.
You should put some kind of anti-seize compound on the new plug threads to
make it easier to remove when you change plugs again.

Good Luck. Bearman
 
You must log in or register to reply here.

Latest threads

Back
Top