TSquared
New Member
Hi,
Last night my ABS dashboard light came on. I used the jumper wire at the connector and get a one flash code on the ABS light. I have checked all the wheel speed sensors and they all ohm out FL: 855 Ohms, FR: 888 Ohms, RL: 1234 Ohms, and RR: 1297 Ohms. I have cleaned all the tone pulser rings and wheel speed sensors. I measured the impedance of the pump motor at the relay, and it reads 0.4 Ohms, which I find very low almost a short, but the fuse is not blown. Any Ideas?
I saw this document on this forum, but I cannot open it. http://www.tegger.com/hondafaq/faq.html#ABS. I believe this is a work around, so the dash light stays off? Can I still get parts for this old car or find someone to work on it?
Last night my ABS dashboard light came on. I used the jumper wire at the connector and get a one flash code on the ABS light. I have checked all the wheel speed sensors and they all ohm out FL: 855 Ohms, FR: 888 Ohms, RL: 1234 Ohms, and RR: 1297 Ohms. I have cleaned all the tone pulser rings and wheel speed sensors. I measured the impedance of the pump motor at the relay, and it reads 0.4 Ohms, which I find very low almost a short, but the fuse is not blown. Any Ideas?
I saw this document on this forum, but I cannot open it. http://www.tegger.com/hondafaq/faq.html#ABS. I believe this is a work around, so the dash light stays off? Can I still get parts for this old car or find someone to work on it?
